Innohep 16,000 IU anti-Xa/0.8 ml solution for injection in pre-filled syringes

Spain
Brand name Innohep 16,000 IU anti-Xa/0.8 ml solution for injection in pre-filled syringes
Form solution for injection in a pre-filled syringe
Active substance / Dosage
Prescription type Prescription Only Medicine
Registration number 79413
Manufacturer Leo Pharma A/S
Innohep 16,000 IU anti-Xa/0.8 ml solution for injection in pre-filled syringes solution for injection in a pre-filled syringe

Patient Information Leaflet

Introduction

innohep 16,000 IU anti-Xa/0.8 ml solution for injection in pre-filled syringes
(20,000 IU anti-Xa/ml)
tinzaparin sodium

Read all of this leaflet carefully before you start using this medicine because it contains important information for you.

  • Keep this leaflet, as you may need to read it again. If you have any further questions, ask your doctor, pharmacist, or nurse.
  • This medicine has been prescribed for you only, and you should not give it to others, even if they have the same symptoms as you, because it could harm them.
  • If you experience any side effects, talk to your doctor, pharmacist, or nurse, even if the side effects are not listed in this leaflet.
  • Throughout this leaflet, the term innohep will refer to "innohep 16,000 IU anti-Xa/0.8 ml solution for injection in pre-filled syringes".

Contents of this leaflet

  1. What innohep is and what it is used for
  2. What you need to know before using innohep
  3. How to use innohep
  4. Possible side effects
  5. How to store innohep
  6. Contents of the pack and other information

1. What innohep is and what it is used for

innohep is a medicine that inhibits the blood's natural ability to form clots (coagulation).

  • innohep is used to treat blood clots and to prevent the formation of further clots in adults.

You should consult a doctor if your condition worsens or does not improve.

2. What you need to know before using innohep

Do not use innohep

  • if you are allergic to tinzaparin sodium or any of the other ingredients of this medicine (listed in section 6).
  • if you have or have had heparin-induced thrombocytopenia.
  • if you have a serious bleeding condition (e.g., in the brain, spinal cord, eyes, or stomach).
  • if you have a severe heart infection (infective endocarditis).
  • if you are scheduled to receive spinal or epidural anesthesia or a lumbar puncture.

Warnings and precautions

Talk to your doctor or nurse before using innohep

  • if you know you have a tendency to bleed.
  • if you are being treated with other medicines administered by intramuscular injection.
  • if you have low platelet levels in your blood.
  • if you have high levels of potassium in your blood (hyperkalemia).
  • if you have a prosthetic heart valve.
  • if you have kidney problems.

Children and adolescents

innohep is not indicated for use in children and adolescents.

Using innohep with other medicines

Tell your doctor or pharmacist if you are taking, have recently taken, or might need to take any other medicines. Some medicines may interact with the effect of innohep.

Inform your doctor if you are taking any of the following medicines, as they may increase your risk of bleeding:

  • Medicines for inflammation and pain, especially non-steroidal anti-inflammatory drugs (NSAIDs), such as acetylsalicylic acid
  • Medicines used to dissolve blood clots (thrombolytic agents)
  • Medicines that block the action of vitamin K (vitamin K antagonists)
  • Activated protein C
  • Direct factor Xa and IIa inhibitors

Pregnancy and breastfeeding

If you are pregnant or breastfeeding, think you may be pregnant, or are planning to become pregnant, consult your doctor or pharmacist before using this medicine.

innohep in pre-filled syringes can be used during all trimesters of pregnancy.

If epidural anesthesia is required, you must inform your doctor that you are using innohep.

Inform your doctor or nurse if you have a prosthetic heart valve.

Driving and using machines

innohep does not affect the ability to drive or operate machinery.

innohep contains sodium metabisulfite

  • Because it contains sodium metabisulfite as an excipient, innohep may rarely cause severe allergic reactions and bronchospasm.
  • This medicine contains 40 mg of sodium (the main component of table/cooking salt) per ml. This is equivalent to 2% of the maximum daily recommended sodium intake for an adult.

3. How to use innohep

Follow exactly the administration instructions for this medicine given by your doctor or nurse. If in doubt, consult your doctor or nurse again.

During treatment, your doctor may request routine blood tests to assess the effect of innohep.

innohep must be injected under the skin (subcutaneous injection). Administration of other medications by intramuscular injection should be avoided during treatment with innohep due to the risk of hematoma formation.

The recommended dose is:

175 anti-Xa IU per kg of body weight administered once daily.

Your doctor will determine the appropriate dose for you.

Treatment should be given once daily for 6 days, and may be extended up to 6 months. The need to extend treatment beyond 6 months must be evaluated by your doctor. Your doctor will inform you of the duration of your treatment.

Instructions on how to inject innohep:

  1. Wash your hands thoroughly before injecting this medicine. Clean the skin around the injection site with an alcohol swab and allow it to dry without rubbing.
Two hands holding a syringe with a needle, and an arrow indicates a leftward pulling motion to remove the cap or safety cover
  1. Open the syringe container by fully lifting back the colored cap and remove the syringe.

Inspect the contents of the syringe before use. If you notice cloudiness or a precipitate in the medicine, do not use it and take another syringe. The medicine may have a yellowish tint during storage, but it may still be used as long as the solution is clear and the expiry date has not been exceeded. Each syringe may only be used once.

One hand holding a syringe vertically while the
  1. Bend the safety device downwards, separating it from the needle protective cap.
Two hands assembling a syringe with a protective cap and a thin needle for drug preparation
  1. Remove the needle protective cap without twisting it. Adjust the syringe content to the dose prescribed by your doctor. Expel the excess volume by pressing the plunger while the syringe is held vertically. Do not pull the plunger backwards, and do not remove the air bubble present in the syringe. If the air bubble is not properly positioned next to the plunger, gently tap the syringe until the air bubble is correctly positioned.
One hand holding a syringe and inserting the
  1. Gently grasp a skin fold without pressing, between the thumb and index finger of one hand, and with the other hand, insert the needle vertically and slowly into the skin fold, i.e., at a right angle to the skin.
Medical diagram showing three body zones with circles indicating injection sites on the
  1. Inject the required dose slowly into the fatty tissue, for example, the skin of the abdominal area, the front of the thighs, the lower back, or the back of the arms. Wait a few seconds to allow the solution to disperse before withdrawing the needle and releasing the skin fold.

  2. Clean the area with gauze if bleeding occurs. For the next injection, choose a different injection site (for example, alternating between the left and right side of the abdomen).

One hand holding an injection pen tilted downward, with a curved arrow indicating a rotational movement toward the skin One hand gripping an injection pen angled toward a flat surface, with a curved arrow indicating a rotational motion toward the
  1. Bend the safety device back to its original position so that it lies parallel to the needle. Then, with the safety device flat against a hard surface, press downward until the needle is locked inside the device.
Two hands removing a needle from a glass vial, with a leftward-pointing arrow indicating the withdrawal motion
  1. The used syringe, with the needle pointing downward, may be placed back into its original container or into a sharps disposal container. This makes the syringe safe, and the container with the syringe or the sharps disposal container can be returned to a hospital or pharmacist for destruction.

If you use more innohep than you should

If you are treated with more innohep than needed, bleeding may occur. Contact your doctor or nurse immediately if you feel unwell or think you have administered too high a dose of innohep.

If you forget to use innohep

Do not inject a double dose to make up for a missed dose. If you have missed more than one dose, consult your doctor as soon as possible.

If you stop using innohep

If you stop using innohep, the blood-thinning effect will cease. Do not interrupt treatment with innohep without consulting your doctor or nurse.

If you have any further questions about the use of this medicine, ask your doctor or nurse.

4. Possible adverse effects

Like all medicines, innohep can cause adverse effects, although not everyone experiences them.

Serious adverse effects:

Serious adverse effects requiring immediate medical attention have been observed rarely during treatment with innohep. If you experience any of the following symptoms, contact your doctor immediately or go to the nearest hospital for urgent treatment.

  • Severe allergic reaction. Symptoms include sudden onset of a severe skin rash, swelling of the throat, face, lips or mouth, and difficulty breathing.
  • Severe bleeding. Symptoms include red or brown urine, tar-like stools, unusual bruises (very painful, extensive or dark), and any bleeding that does not stop.

The following adverse effects have been observed with innohep administration:

Common: may affect up to 1 in 10 people

  • Bleeding: May lead to complications such as anaemia (low number of red blood cells in the blood) or bruising

  • Reactions at the injection site (including bruising, bleeding, pain, itching, redness, swelling and hardening at the injection site)

Uncommon: may affect up to 1 in 100 people

  • Thrombocytopenia (decrease in the number of platelets in the blood)
  • Hypersensitivity (allergic reaction)
  • Bruising and skin discoloration
  • Increased liver enzyme levels
  • Dermatitis (inflammation of the skin)
  • Skin rash and itching

Rare: may affect up to 1 in 1,000 people

  • Heparin-induced thrombocytopenia (decrease in the number of platelets in the blood due to heparin treatment)
  • Thrombocytosis (increase in the number of platelets in the blood)
  • Angioedema (swelling of the face, lips and tongue)
  • Anaphylactic reaction (see above “Severe allergic reaction”)
  • Hyperkalaemia (increased potassium levels in the blood)
  • Toxic skin rash
  • Skin necrosis (death of skin tissue)
  • Urticaria (hives)
  • Osteoporosis, observed with long-term treatment
  • Priapism (prolonged, often painful erection without prior sexual stimulation)

Paediatric population

Limited information from a clinical trial and post-marketing data indicates that the adverse reaction profile in children and adolescents is comparable to that observed in adults.

Reporting of adverse effects

If you experience any adverse effect, consult your doctor, pharmacist or nurse, even if it is a possible adverse effect not listed in this leaflet. You may also report them directly via the Spanish Pharmacovigilance System for Human Medicinal Products: https://www.notificaram.es. By reporting adverse effects, you can help provide more information on the safety of this medicine.

5. Innohep storage

  • Keep this medicine out of the sight and reach of children.

Do not use this medicine after the expiry date stated on the packaging. The expiry date refers to the last day of the month indicated.

  • No special storage conditions are required.
  • Do not use this medicine if you notice cloudiness or a precipitate in the syringe.
  • The solution may develop a yellowish tint during storage, but this does not affect the quality of the product, which remains safe for use.
    • Medicines should not be disposed of via wastewater or household waste. Return empty containers and unused medicines to the SIGRE collection point at your pharmacy. If you are unsure, ask your pharmacist how to properly dispose of unused containers and medicines. This helps protect the environment.

6. Contents of the pack and other information

Composition of innohep

  • The active substance is tinzaparin sodium. Each ml of injectable solution contains 20,000 IU anti-Xa of tinzaparin sodium.
  • The other components are sodium metabisulfite (E 223), sodium hydroxide, and water for injections.

Appearance of the product and contents of the pack

Injectable solution.

Clear glass syringes containing a colourless or pale yellow solution, free from turbidity and any depositing material when the syringe is left at rest.

Pack sizes:

  • 0.8 ml (16,000 IU anti-Xa), packs containing 2, 6, 10, 30, 50, and 100 syringes.

Only some pack sizes may be marketed.

Marketing Authorization Holder and Manufacturer

Marketing Authorization Holder:

LEO Pharma A/S

Industriparken 55,

DK-2750 Ballerup

Denmark

Manufacturer:

Laboratoires LEO S.A.

39 Route de Chartres,

FR-28500 Vernouillet Cedex

France

Date of the most recent review of this leaflet: December 2019.

Detailed and up-to-date information on this medicinal product is available on the website of the Spanish Agency of Medicines and Medical Devices (AEMPS) http://www.aemps.gob.es/.